How to Reset the Zebra Wireless Barcode Scanner?

Retail and warehouse management sees a heavy reliance on the reliability and precision of barcode scanning technology. Zebra wireless barcode scanners are among the most trusted for these purposes. They operate at peak reliability for maximum uptime to help ensure the on time supply chain. But even the best-made machine can encounter issues like the scanner laser not working. Use this Zebra wireless barcode scanner reset guide to remedy this issue and avoid a costly halt in operations.

Understanding Common Laser Issues with Zebra Scanners

Troubleshooting the laser of a Zebra scanner

The first thing to note before you dive into the troubleshooting process is why a Zebra wireless barcode scanner may act up. Here are a few common reasons:

Dirty scanner window: The window that the laser departs from could have dirt on it.

Auto-sense is on: You may have scanning mode changed from the “Use Trigger” setting to the “presentation” mode.

Battery is low Ceiling Forklift: A weak or dying battery could impact a scanner’s performance.

Resetting the Zebra Wireless Barcode Scanner

When the laser of your Zebra scanner is not working you’ll need to reset it to get it back online. Just follow these simple steps to get the job done.

Before you power up your scanner make sure your scanner is located in a well ventilated room, the chamber is free from debris, the battery is installed, and it’s ready to be powered up.

For whoever is using the scanner’s interface, be sure to remove your hand from the scanner trigger and any visible laser line when you issue a remote reset command.

Start by tapping or clicking on settings on the scanner than tap or click on reset.

For example to reset the MT2000, MT2070 and MT2090 scanners ensure the scanner is powered off and that your battery is inserted then hold down the number 1 key and power up your scanner. When you hear the short low-pitched beeps you can release the number 1.

After you follow the above steps and your problem has not been resolved, try the reset operation again. Also ensure that you’re using the correct scanner settings before you use it in your operations. The incorrect settings will alter your scanner’s functionality.

Contact Us Now for Expert Assistance

E.D. Systems Inc. is a top supplier microprocessor products and storage solutions. With the Zebra wireless barcode scanners, it also offers some of the most trusted and useful inventory scanner equipment and software to ensure clients’ needs are met and overhead is kept to a minimum.

The company’s first-rate customer service team is always on hand to guide you through the process of troubleshooting your scanners. So, if you’re a warehouse manager or retailer that’s looking to improve efficiency and effectively manage hundreds of thousands of codes, call E.D. Systems Inc. today for the best product recommendations!

In conclusion, a malfunctioning laser on your Zebra Wireless Barcode Scanner can disrupt your operations and impact productivity. However, with the right troubleshooting steps and expert assistance, you can quickly reset your scanner and address laser-related issues.

Remember to check power and battery levels, inspect and clean optics, update firmware and software settings, perform a hardware reset if necessary, and contact technical support for further assistance if needed. Don't let laser problems hold your business back – reach out to E.D. Systems Inc. today for reliable solutions.